Wednesday, 19 April 2017

Metal Inlay


Another vanillabox sample piece, this time I wanted to demonstrate what could be done with a little bit of imagination. The large block of oak was cut by hand and the pattern cut into the top surface. Each ring was made by putting multiple low power cuts next to each other, this left a gap that was large/deep enough to accept a strip of metal which was hammered into place. The whole thing was sanded, varnished and polished within an inch of its life.

I was intending to write an instructable about how to do this but somebody else beat me to it so if you want to make your own inlays I would suggest you read this instead.