Saturday, 6 December 2014

Large Ring Lift


After seeing my massive marble machine ring lift I was asked to replicate the lift only to make a lifting mechanism for golf balls. This one needed to be motorised, slightly larger but didn't need the spiral so I basically ended up redrawing the whole thing. There was a minor issue with the drive gear shaft shearing off so I replaced the gear with an acrylic version and it seems to be running fine. It works well though and I can't wait to see the rube goldberg it's going to be used in.







Thursday, 4 December 2014

Christmas Badge Round up


I made 6 badges in total but these are the four I am now listing in my web stores, it's not too late to get them for Christmas.  The amusing thing about working on tiny scale items in a massive laser is that the honeycomb bed just becomes additional work surface and you can keep multiple sheets of wood/veneer ready for cutting on the bed.

 



Christmas Badge 6


I saved the best for last. I'm really pleased with the stripey candy effect and the blue ribbon.

Wednesday, 3 December 2014

Christmas Badge 5


Another 1 from the trio, I learnt my lesson and simplified this a little. The nose is still 1.5mm wide so it is in danger of being lost. The blue wood veneer is great.

Tuesday, 2 December 2014

Christmas Badge 4


This is the same tree from the Christmas Trio but obviously much smaller. Too small in fact, the dots are 2mm wide and the strips are 1.5mm wide. It's a nice badge but I don't want to make more than one.

Monday, 1 December 2014

Christmas Badge 3


There is a small etch all round the edge of these holly leaves. It make a big difference to the final piece but it did increase the cutting time from seconds to 2 minutes, worth it though.

Sunday, 30 November 2014

Christmas badge 2


Not entirely happy with the alignment of these veneers, they slipped while gluing but also not very happy with the overal design so will abandon this one here.